IVOLTAIR
IVOLTAIR UV Bank with Ozone Generation System

Odour control

UV Bank with Ozone Generation System

Add-on UV and ozone module installed after the IVOLTAIR ESP for odour removal and air disinfection. Five models, up to 660 µW/cm² UV output.

Treatment
Dual action: UV irradiation and ozone oxidation in one module
Max UV output
660 µW/cm² (IV15200UV)
Rated lamp life
10,000 hours

Technical specification

SeriesIV-UV (datasheet IVA-DS-UV-01)
TreatmentDual action: UV irradiation and ozone oxidation in one module
Max UV output660 µW/cm² (IV15200UV)
Rated lamp life10,000 hours
Control unitDigital timer with run-hours display for planned lamp replacement
Operator interface“UV ON” blue LED indication
Lamps and ballastsLamps to IS 2418, ballasts to IS 13021, CE-compliant HV supply
InstallationDownstream of an IVOLTAIR ESP section
ApplicationOdour removal and air disinfection

Models

ParameterIV2500UVIV5000UVIV7600UVIV10200UVIV15200UV
UV lamp wattage40 W × 2130 W × 2130 W × 2130 W × 2130 W × 6
Number of UV lamps22226
Total UV lamp power80 W260 W260 W260 W780 W
UV output (µW/cm²)115420420420660
Ozone output (g/h)*1.244.24.28.412.6
Pairs with ESPIV2500IV5000IV7600IV10200IV15200

* Ozone output at standard conditions. Total UV lamp power is the sum of rated lamp wattages. Each model is sized to sit directly after the matching IVOLTAIR ESP.

How it works

  1. Pre-filtration (ESP): smoke, grease and particulate matter are captured in the upstream electrostatic precipitator.
  2. UV irradiation: the cleaned air passes banks of UV lamps that inactivate airborne micro-organisms.
  3. Ozone oxidation: ozone produced by the lamps oxidises odour-causing compounds in the duct before discharge.

Safety

  • UV radiation and ozone are hazardous to eyes and skin. Never look at energised lamps.
  • Isolate the electrical supply before opening any access door or panel.
  • Allow residual ozone to disperse before entering the cabinet or duct.
  • Installation and servicing by qualified personnel only.

Maintenance

  • Monitor lamp hours on the run-hours display and replace lamps at 10,000 hours.
  • Keep lamp surfaces clean to maintain rated UV output.
  • Check the “UV ON” indication during routine inspection.
  • Use only genuine IVOLTAIR replacement lamps and ballasts.

Send us your air volume and application. We’ll size the unit.

Free site inspection and duct-velocity advice with every enquiry.

Chat with us